Keys Of The M300 - Dräger Infinity M300 Series Instructions For Use Manual

Keys of the M300

Key Function
Depending on the enabled setting at the ICS (see page 205), pressing this key does one of
the following:
– Generates a strip recording and stores an event at the ICS
– Cancels a strip recording that was initiated from the M300
If the Staff alert setting is enabled at the ICS (see page 205), pressing this key does the
following:
– Sends the Staff alert message to the ICS
– Triggers an alarm tone of medium priority at the ICS
Pressing these keys does the following:
– Scrolls through waveforms on the M300 screen
– Increases or decreases a setting in an M300 window
– Turns the M300 on (press both keys longer than 3 seconds)
Pressing this key does one of the following:
– Turns the M300 screen on and off (press and hold the key longer than 3 seconds)
– Scrolls through the Main screen, Lead Status screen, Volume screen, and Demograph-
ics screen
– Cancels standby mode
– Resumes monitoring and displaying the patient data at the M300 after discharge was ini-
tiated from the ICS
– Accepts or confirms user-selected values
If the Alarm pause setting is enabled at the ICS (see page 228), pressing this key does the
following:
– Suppresses alarm monitoring of the corresponding patient at the ICS and at the M300.
The alarm pause period is a pre-configured time of 1 to 5 minutes (press and hold the
key more than 3 seconds if the screen is turned on)
– Cancels an alarm pause in progress. If an alarm condition is present, alarms sound again
immediately
Instructions for use – Infinity ® M300 and M300+ series – VG3.0
System overview
47