Accessing The Spo 2 Setup Page; Spo Parameter Setup Functions - Dräger Infinity M300 Series Instructions For Use Manual

SpO and pulse rate monitoring with Nellcor and M300
2
Accessing the SpO
1 Open the BedView screen by selecting the viewport of the telemetry patient on the ICS Main screen.
2 Select the Telemetry/ Parameters button.
3 Select the Layout/ Parameters tab (if not already selected).
4 Select the SpO2 tab.
SpO parameter setup functions
2
All SpO2 parameter setup functions take place in the ICS SpO2 setup page (see "Accessing the SpO
setup page" on page 190).
To configure the alarm functions, see page "M300 alarm ranges and defaults" on page 134.
Selection
SpO2 monitoring
Bar graph
Color
190
setup page
2
Available settings
On, Off (default)
On (default), Off
Red, white (default), yellow,
green, light blue, blue, purple,
orange
Instructions for use – Infinity
Description
Turns SpO2 monitoring on or off.
Displays a bar graph pulsating at pulse rate with
the amplitude being proportional to the pulse
strength. Displays only on the M300 not the ICS.
Determines the color of the waveforms and the
parameter labels and values.
® M300 and M300+ series – VG3.0
2