1F8F Jam Code Occurs With Versions Of Finisher System Software Earlier Than Ver. 29.02 (Staple/Booklet Finisher-D1); 1096/11A1/11A2/11A3 Jam Codes Due To The Faulty Finisher Software Sdl-Stch (Booklet Fin-D1) - Canon imageRUNNER ADVANCE 8105 Series Manual

Symptom
112F/1F8F Jam Code occurs with versions of Finisher system software earlier than Ver. 29.02
(Staple/Booklet Finisher-D1)
[Inspected by Canon Inc. ]
Description
112F/1F8F jam code occurred continuously.
-112F: Finisher Error Avoidance jam
-1F8F: Saddle Error Avoidance jam
Cause
The device has a function to display an error code in case an error avoidance jam has occurred several
times continuously. But, this function didn't work with versions of Staple/Booklet Finisher-D1 system
software earlier than Ver. 29.02 (SORTER Ver 29.02).
Field Remedy
Upgrade the Staple/Booklet Finisher-D1 system software to Ver. 29.02 (SORTER Ver. 29.02) or later.
When an error avoidance jam has occurred several times continuously, the device displays an error code
corresponding to the error state. So, please take a solution for the displayed error code.
When upgrading after MN-CONT Ver.40.13, use the combination of versions shown below:
MN-CONT: Ver.41.03/LANG: Ver.41.03/DC-CON: Ver.34.01/R-CON: Ver.22.01/COPY-AP:
Ver.41.04/BOX-AP: Ver.41.04/SEND-AP: Ver.41.01/S-LNG: Ver.30.05/Staple/Booklet Finisher-D1
SORTER: Ver.29.02/SDL-STCH: Ver.13.02
Symptom

1096/11A1/11A2/11A3 Jam codes due to the faulty finisher software SDL-STCH (Booklet Fin-D1)

[Inspected by Canon Inc. ]
Description
1096/11A1/11A2/11A3 Jams occurred when using the booklet mode.
-1096: Saddle Vertical Path Sensor delay jam
-11A1: Saddle Feed Path Sensor feed stationary jam
-11A2: Saddle Delivery Sensor feed stationary jam
-11A3: Saddle Inlet Sensor feed stationary jam
Cause
Due to the bug of the finisher software SDL-STCH, the back end retaining lever does not operate while the
motion of booklet mode, and the first and second sheet of printing strike each other.
Field Remedy
Upgrade the finisher software SDL-STCH to Ver.10.01 or later.
[Caution] When to upgrade to SDL-STCH Ver.10.01 or later, pay attention to the combination of the
versions.
pg. 168