Canon imageRUNNER ADVANCE 8105 Series Manual page 126

7) Turn the tensioner assembly in the clockwise direction until the right edge of the long hole for the TP
screw in the tensioner assembly touches the TP screw [6], and securely tighten the TP screw [6].
8) Put the timing belt [2] back in place.
9) Slightly loosen the TP screw [6], so that the tensioner assembly is turned back a little in the
counterclockwise direction by the tension spring. Check that tension is applied to the timing belt [2], and
then tighten the TP screw [6] again.
10) Put the flywheel back in place, and close the controller box assembly.
11) Remove the drum cleaning unit and clean it.
12) Make a copy with test chart, and check that there is no problem in the image.
[Replacement Parts]
FM4-9816 TENSIONER ASSEMBLY
FS1-9010 SCREW, STEPPED, M3
pg. 126