Canon imageRUNNER ADVANCE 8105 Series Manual page 138

14-2) Loosen two screws [1] and adjust the position of the swing guide solenoid [2] so that the gap
between the swing guide upper cover and the staple safety switch's arm becomes 1.5mm plus or minus
0.5mm. Then, tighten the 2 screws [1].
15) Reassemble the parts in reverse order of the procedure in the step 1).
16) Make proof copy with 5 A4 sheets collating in 3 sets and check to see if jam does not occur and no
abnormalities observed with the operation assembly/the swing guide/buffering operation.
[Replacement parts]
4C5-0098-000 SHAFT, ROLLER
FC5-4729-000 BUSHING
pg. 138