Symptom
0C10/0112/0113/0213/0114/0115 jam code owing to the defect of the Reverse Upper Flapper
[Inspected by Canon Inc.]
Description
0C10 jam occurred in Field cases.
- 0C10: Fixing Toenail jam
- 0112: Inner Delivery Sensor Delay Jam
- 0113: Outer Delivery Sensor Delay Jam
- 0213: Outer Delivery Sensor Stationary Jam
- 0114: Reverse Vertical Path Sensor Delay Jam
- 0115: Duplex Left Sensor Delay Jam
Cause
The malfunction of the Reverse Solenoid Assembly[2] that drives the Reverse Upper Flapper[1] caused jam.
Field Remedy
Check the operation of the Reverse Solenoid following the procedure below, and if the solenoid is not
working, prepare and replace with the Reverse Solenoid Unit[1](FM4-5141). If the jam occurs despite the
solenoid is working fine, then check other factors.
1) Go to Service mode > Mode List > COPIER > Function > PART-CHK > Enter "4" to SL and select the
Reverse Solenoide.
2) Go to Service mode > Mode List > COPIER > Function > PART-CHK > Select SL-ON and press "OK"
button, then check the operation of the Reverse Solenoid. An operational sound is made after pressing the
OK button, the display changes from START to ACTIVE, and about 10 seconds after that it changes again to
OK, then the check of the operation is completed.
[Replacement Part]
FM4-5141 REVERSE SOLENOID ASS'Y
pg. 65