9) Reattach the parts in the reverse order from the step 7) to 4).
[Caution] When attaching the separation claw holder assembled to the AP kit assembly, put the shaft [6]
through the 2 torsion springs, and then attach it so that the torsion springs [7] get into under the cleaner
case [9].
10) Move the separation claw holder to check if the spring force of the torsion spring is acting.
11) Reinstall the parts in the reverse order from the step 3).
12) When the ETB is damaged, replace the ETB as well.
13) Make a copy with the test chart to check if the output image has no abnormality.
[Replacement Part]
FC9-4860 HOLDER, SEPARATION CLAW
pg. 130