Canon imageRUNNER ADVANCE 8105 Series Manual page 305

b) Procedure to adjust the right door hinge
1) Remove the right door [1] from the main body.
2) Loosen the 2 screws [7] with the new type right door hinge [B] is attached to the right door [1]. (No need to
remove these screws.)
Meanwhile, the sheet metal part [8] of the right door hinge [B] is placed at the center of the scale mark [c] in
the initial state.
3) Slide the sheet metal part [8] of the new type right door hinge [B] to the right by 1 scale mark [c] as shown
in the below figure. Then tighten the 2 screws [7].
[Caution] Pay attention not to let the sheet metal part [8] ride onto the 2 bosses [9].
4) Attach the right door [1] to the main body.
5) Repeat the procedure from the above step 6 to 10 of the <Procedure to replace the right door hinge> for
several times. If the right door [1] does not get half-locked, or proper detection of the half-lock of the right
door [1] as a door open error is confirmed, then the work is completed.
[Caution] When the right door [1] is closed after attaching the new type right door hinge [8], if the right door
pg. 305