Table of Contents
Advertisement
Patient Monitor User Manual
8.8 Viewing the Vital Screen
To view the vital screen, the user can press the shortcut key
select Menu > Display Setup > View Selection > Vital.
8.9 Viewing the Bed View Window
The Bed View window allows you to view one waveform, numeric information of all parameters
and alarm information from another bed on the same network. The monitor enables a maximum
of eight beds to be viewed.
NOTE:
1
The IP addresses of the monitors configured with bed view function should share the
same network segment. The IP addresses of the monitors on the same LAN should
be unique from each other; you cannot use the bed view function in the monitors in
which an IP address conflict exists.
2
In order to use the bed view function without impediment, you need to restart the
monitor after you change its IP address.
3
To use the bed view function smoothly, make sure the network connection is in good
condition.
4
In the Bed View window, you cannot view the over-limit alarms of physiological
parameters occurring on other beds. Besides, arrhythmia alarms and vital alarms will
be indicated only by alarm icons.
5
The bed view results are for reference only.
- 85 -
User Interface
on the screen directly or
Advertisement
Table of Contents
