EDAN iM50 User Manual page 168

Patient Monitor User Manual
The LEGI Indicator (3) is located around the capnography connector on the front of the device.
The LEGI indicator illuminates in different colors depending on the state of the device as
described in the table:
LEGI Indicator
Steady green light
Blinking green light
Steady red light
Blinking red light
Note: Without a NomoLine sampling line connected, the LEGI Indicator does not illuminate.
With no sampling line connected, the Masimo sidetream CO
mode. Once a sampling line is connected, the Masimo sidetream CO
measuring mode and starts delivering gas data.
Capnography Display
Parameters and measurements display on the screen of the monitor that the Masimo Sidetream
CO module is connected to.
2
Cleaning
Cleaning of the Masimo sidetream CO
accordance with hospital, as well as local and governmental regulations.
To avoid electric shock, always physically disconnect the modules and all patient
connections before cleaning.
To avoid permanent damage to the module, do not use undiluted bleach (5% - 5.25%
sodium hypochlorite) or any other cleaning solution not recommended.
NOTE:
To prevent cleaning liquids and dust from entering the NomoLine capnography gas
analyzer through its sampling gas inlet connector, keep the sampling line fitted while
cleaning the module.
The surfaces of the module may be cleaned with the following solution(s):
• 70% ethyl alcohol
• 70% isopropyl alcohol
• Glutaraldehyde Solution
Status
Capnography monitoring in operation and OK
Zeroing in progress. Refer to Zeroing the sensor
Sensor error
Check the sampling line (possible occlusion)
module should be performed at regular intervals or in
2
WARNING
CAUTION
- 156 -
module stays in a low-power, sleep
2
module switches to
2
Monitoring CO
2