Table of Contents
Advertisement
Patient Monitor User Manual
4
To zero the sensor, please refer to Zeroing the Sensor .
5 Install the airway adapter at the proximal end of the circuit between the elbow and the
ventilator Y-section.
1
No routine user calibration is required.
2
Accuracy is affected by temperature and barometric pressure.
NOTE:
1
If the catheter falls off during the measurement, it is necessary to re-zero after the
catheter is well connected, and then measurement can be performed.
2
Replace the airway adapter, if excessive moisture or secretions are observed in the
tubing or if the CO
status.
3
To avoid cross infection, use only sterilized, disinfected or disposable airway
adapters.
4
Inspect the airway adapters prior to use. Do not use it if airway adapter appears
Connecting Sensor
Connecting Airway Adapter
WARNING
waveform changes unexpectedly without a change in patient
2
- 158 -
Monitoring CO
2
Advertisement
Table of Contents
