Table of Contents
Advertisement
Patient Monitor User Manual
To admit a patient by barcode,
1. The user can scan the barcode through scanner, then a message is displayed to ask the user to
confirm the patient update.
2. Click No to cancel this operation; click Yes, the Patient Info window is displayed and the
corresponding patient information is updated according to the identified MRN. If the monitor
is connected with the network server through the gateway, the monitor will automatically
inquire for patient information from the network server via MRN. As soon as the MRN is
successfully found on the network server, the corresponding patient information will be
updated to the monitor. Otherwise, prompt information will be displayed to notify the user
that network is not available or no patient information is matched. If patient information is
modified on the network server, prompt information will also be sent to inform the user of
the update.
NOTE:
1
When the monitor is in keyboard interface and patient information interface, admitting
patient via barcode scanner is not available.
2
The start and end code should be set before using scanner to update patient,
otherwise the barcode can't be recognized normally.
3
Patient information obtained from network server cannot be edited.
7.5 Managing Patient Information
7.5.1 Editing Patient Information
To edit the patient information after a patient has been admitted, select Menu > Patient Setup >
Patient Info., and make the required changes on the popup interface.
If the monitor is equipped with a barcode scanner, the user can scan the patient's barcode to enter
the patient's medical record number (MRN). When patient's MRN is modified, the user can click
on
to obtain the patient information from network server. Otherwise, only MRN is
updated.
NOTE:
Switching patient type will change the current configuration.
7.5.2 Obtaining Patient Information from the Network Server
The user can obtain patient information from the network server to the monitor. To obtain patient
information from the network server,
1. Select Menu > Patient Setup > Network Admit.
2. Input the query conditions (Department, Date of Admission), and then click
including all the patients that meet the query conditions is displayed.
3. Select a patient from the patient list, and click Admit. The corresponding patient information
in the monitor will be updated after user's confirmation. Click View to display the detailed
- 81 -
Managing Patients
. A list
Advertisement
Table of Contents
