EDAN iM50 User Manual page 85

Patient Monitor User Manual
Message
Zeroing and
Failed
Sensor Off,Fail.
Invalid Time,Calibration Fail.
Unable to Calibrate in Demo
Mode
Calibrating...
CO Self-Testing
2
IBP alias collision
C.O. Lack Param
AG Self-Testing......
(Masimo AG module)
AG Span Calib In Progress
(Masimo AG module)
MultiGas Zero in Progress
AG Is Starting
(Dräger AG module)
AG Standby
(Dräger AG module)
AG Zero In Progress
(Dräger AG module)
AG Is Warming Up
(Dräger AG module)
AG Changing to Standby
(Dräger AG module)
AG Changing to Meas.
(Dräger AG module)
AG Agent Low Concentration
(Dräger AG module)
AG Agent Overflow
(Dräger AG module)
AG Agent Calculate
(Dräger AG module)
Cause
Calibration
Zeroing is not performed prior calibration.
Perform calibration when the sensor is off.
Time is not set up prior calibration.
Perform calibration in Demo Mode.
Calibration is in progress.
CO module is performing a power-on self-test.
2
The same IBP label appears.
Parameter is not configured for C.O. measurement.
AG module is performing a power-on self-test.
The calibration of AG module is in progress.
The zeroing of AG module is in progress.
AG module is starting.
User sets Work Mode to Standby.
The zeroing of Scio module is in progress.
Scio module is warming up and is operating at reduced
accuracy.
Work Mode is switching to Standby from Measure.
Work Mode is switching to Measure from Standby.
Measured agent concentration is low.
The gas concentration has increased above the maximum
threshold.
Usually it comes up if no single agent history is available
and a mixture situation occurs.
- 73 -
Alarm Information