Store And Recall - R&S NGE100B User Manual

®
R&S NGE100B

6.8 Store and recall

The [Store Recall] function is disabled when the instrument is in editing mode.
See
Upon power-up, the instrument loads the stored settings from memory location M1 with
the exception on EasyArb parameters. Auto saved parameters are also applied during
startup.
The R&S NGE100B output state of all channels (Ch 1, Ch 2, Ch 3) is disabled when
the recall function is activated.
Auto save instrument settings
Auto save of instrument settings are applied when any of the following parameters
changed:
●
General instrument settings
●
USB connection mode
●
WLAN settings
–
–
–
●
Ethernet settings
The instrument settings can be stored or recalled from memory locations M1 to M5.
The following instrument settings are stored or recalled in the memory location:
●
Fuse settings
●
Protection settings
●
EasyRamp settings
●
Set voltage and current levels
●
1
●
1
1 The EasyArb or DIO settings can only be saved in the respective dialog environment
and all other above instrument settings are not saved when a store function is made.
Similarly, when a recall function is made on the same-stored memory location, only the
EasyArb or DIO settings are recalled.
Store instrument settings
Access:
1. Long press [Store Recall] key to store instrument settings.
User Manual 5601.1343.02 ─ 09
Figure 5-3.
(only with instrument serial number below 110000)
"Module"
"SSID"
"Password"
EasyArb settings
Digital IO settings
Instrument functions
Store and recall
52