Switching On The Instrument - R&S NGE100B User Manual

®
R&S NGE100B
USB connector (11)
The USB connector is a Type-B connector for remote control operation via USB TMC
or USB VCP.
Digital I/O connector (12)
The Digital I/O connector is a 5-pin terminal block for external trigger input or output.
Measurement control can be achieved by means of an external input signal or as an
output signal to trigger other instruments for some measurements.
The Digital Trigger I/O option (R&S NGE-K103) must be installed for this function to be
available in the instrument.
Kensington security slot (13)
A Kensington lock can be anchored to the R&S NGE100B power supply housing to
secure it to a workstation mechanically.

4.2.2 Switching on the instrument

Before switching on the instrument, check that all the instructions in the "Basic Safety
Instruction" brochure and safety measures in previous sections are observed.
Also, check if the value on the voltage selector corresponds to the mains voltage (115
V or 230 V).
To change the power fuse / mains voltage setting:
1. Peel off the yellow label sticker on the AC inlet.
2. Pull out the fuse holder which is located directly on top of the socket.
3. Remove the preloaded fuses from the fuse holder.
4. Check the rating on the caps of both fuses that you want to change.
For more information, see
5. Once verified, insert the fuses into each groove of the fuse holder.
6. Return the fuse holder to its position in the panel.
To switch on the instrument:
1. Connect the power cable to the AC power connector on the rear panel of the R&S
NGE100B.
2. Connect the power cable to the socket outlet.
3. Press [Power] key on the front panel.
The instrument performs a system check, boots the operating system and starts
the R&S NGE100B firmware.
User Manual 5601.1343.02 ─ 09
"Setting voltage selector"
Getting started
Instrument tour
on page 23.
24