Table of Contents
Advertisement
®
R&S
NGE100B
SYSTem:COMMunicate:WLAN:SSID <arg0>
This command defines or queries the SSID string of the access point when the wire-
less interface works as a client.
Parameters:
<arg0>
Options:
7.3 Configuration commands
The following subsystems contain the commands for channel selection, voltage and
current settings for the instrument.
7.3.1 Channel selecting
The INSTrument:Select subsystem contains the commands for selecting the output
channels.
Each channel of the power supply is considered as separate "instrument", which is
required by the SCPI standard. Therefore, the SCPI commands use the INSTRument
node to select a channel.
You can only address the number of channels a device is equipped with, e.g. two chan-
nels for the NGE102 and three channels for the NGE103.
User Manual 5601.1343.02 ─ 09
R&S NGE-K102
Instrument with serial number below 110000
Remote control commands
Configuration commands
76
Advertisement
Table of Contents
