Table of Contents
Advertisement
®
R&S
NGE100B
Suffix:
<IO>
Parameters:
<arg0>
TRIGger:LOGic:DIO<IO> <arg0>
This command sets or queries the trigger logic (Active High/Active Low) of the speci-
fied Digital I/O line.
Suffix:
<IO>
Parameters:
<arg0>
TRIGger:MASTer[:STATe] <arg0>
This command defines or queries the master enable state for the Digital I/O interface.
The state is disabled when any setting has been changed.
Parameters:
<arg0>
TRIGger:OUT:CONDition:DIO<IO> <arg0>
This command sets the trigger condition of the trigger output of the specified Digital I/O
line.
The line triggers when the output of the specified control source is turned off or on
Suffix:
<IO>
Parameters:
<arg0>
User Manual 5601.1343.02 ─ 09
.
1..4
CH1
Trigger input source from Ch 1.
CH2
Trigger input source from Ch 2.
CH3
Trigger input source from Ch 3.
*RST:
CH1
.
1..4
LOW | HIGH
*RST:
HIGH
{OFF | ON}
ON
"Master Enable" state is activated for all DIO interfaces.
OFF
"Master Enable" state is deactivated for all DIO interfaces.
*RST:
OFF
.
1..4
ON | OFF | FUSetrip | CCMode | VOLTlevel | CURRlevel |
CRITevent | ARBitrary
Remote control commands
Advanced operating commands
99
Advertisement
Table of Contents
