Table of Contents
Advertisement
®
R&S
NGE100B
AC inlet with fuse holder (8)
Main supply cord
Do not use detachable mains supply cord with inadequate rating.
For safety reasons, the instrument can only be operated with authorized safety sock-
ets.
The power cable must be plugged in before signal circuits can be connected. Never
use the product if the power cable is damaged. See
instrument",
Voltage selector (9)
Setting voltage selector
The voltage selector is located at the bottom of the R&S NGE100B.
On your first power-on connection, a yellow label sticker is attached over the
Before peeling off the yellow label sticker, make sure the correct fuse rating is used for
the mains voltage.
To set the correct fuse rating, slide the selector according to the voltage selector label.
Figure 4-4: Voltage selector
1 = Voltage selector
2 = Voltage selector label
The voltage selector selects the mains voltage between 115 V and 230 V. See
Table 4-1
Ethernet connector (10)
This connector is used for establishing remote control via SCPI or LXI. See section
"Ethernet Setup" in the user manual for more information on the connection setup.
The Ethernet option R&S NGE-K101 must be installed for this function to be available
in the instrument.
User Manual 5601.1343.02 ─ 09
on page 24 for more information.
for the fuse rating.
Chapter 4.2.2, "Switching on the
1
2
Getting started
Instrument tour
AC
inlet.
23
Advertisement
Table of Contents
