Getting Started; Putting Into Operation - R&S NGE100B User Manual

®
R&S NGE100B

4 Getting started

4.1 Putting into operation

This chapter describes the steps to set up the R&S NGE100B for the first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing
●
Read and observe the "Basic Safety Instructions" delivered as a printed brochure
with the instrument. Note that the basic safety instructions also contain information
on operating conditions that prevent damage to the instrument
In addition, read and observe the safety instructions in the following sections. Notice
that the data sheet may specify additional operating conditions.
Risk of instrument damage during operation
An unsuitable operating site or test setup can cause damage to the instrument and the
connected devices. Ensure the following operating conditions before you switch on the
instrument:
●
The instrument is dry and shows no sign of condensation
●
The instrument is positioned as described in
on page 19
●
The ambient temperature does not exceed the range specified in the data sheet
●
Voltage levels at the input connectors are all within the specified ranges
●
Voltage outputs are correctly connected and not overloaded
Risk of radio interference
This is a class A product. In a domestic environment, this product may cause radio
interference in which case the user may be required to take adequate measures.
User Manual 5601.1343.02 ─ 09
Getting started
Putting into operation
Chapter 4.1.4.1, "Bench operation",
14