Table of Contents
Advertisement
®
R&S
NGE100B
ARBitrary[:STATe] <arg0>
This command activates/deactivates or queries the EasyArb state. ON: Ch 1 is ready
to run arb waveform.
Parameters:
<arg0>
ARBitrary:SAV <arg0>
This command saves EasyArb settings and previous defined arbitrary points into the
respective memory locations M1-M5.
Parameters:
<arg0>
Example:
Usage:
ARBitrary:STARt
This command starts the previous transferred EasyArb waveform in channel 1 if Easy-
Arb is enabled.
Usage:
ARBitrary:STOP
This command stops the EasyArb waveform in channel 1 if EasyArb is running.
Usage:
7.5.2 EasyRamp commands
The VOTage:RAMP subsystem contains the commands for configuring the ramp func-
tion for the output channels.
[SOURce:]VOLTage:RAMP:DURation <Time>
This command sets/queries the EasyRamp duration of the previous selected channel
in seconds. 0.01 s to 10 s in steps of 0.01 s.
User Manual 5601.1343.02 ─ 09
{OFF | ON}
ON
EasyArb state is activated.
OFF
EasyArb state is deactivated.
Range:
0..4
INST 1
ARB:DATA 10,1,0,5,0
ARB:REP 10
ARB:SAV 1
Setting only
Event
Event
Remote control commands
Advanced operating commands
96
Advertisement
Table of Contents
