®
R&S
NGE100B
The R&S NGE100B displays the "Digital IO" dialog. See
Figure 6-9: Digital IO dialog
3. Select the desired DIO interface for configuration.
4. Select "Trigger In" to accept external trigger signal or "Trigger Out" to output the
trigger signal.
5. Set the desired "Channel".
6. Select the desired trigger condition.
See
7. Set the desired "Logic" state.
8. Set the "Status" to "Enabled".
The R&S NGE100B enabled the selected DIO interface and monitor or feedback
the trigger condition on the selected channel.
9. Set the "Master Enable" to "Enabled".
The "Master Enable" is the master DIO interface which activates or deactivates all
the DIO interfaces.
6.7 Advanced functions
The following chapters provide information about the
items found in the [Menu] key.
Access:
1. Press [Menu] key.
2. Select the "Output" menu item.
The R&S NGE100B displays the respective menu item dialog.
User Manual 5601.1343.02 ─ 09
Table 6-1
and
Table
6-2.
Instrument functions
Advanced functions
Figure
6-9.
EasyArb
and
EasyRamp
menu
48