Usb Connection - R&S NGE100B User Manual

®
R&S NGE100B
6. To disconnect, select "Disconnect" in the WLAN dialog.

6.9.2 USB connection

Change of USB class
If a change in "USB Class" is detected (i.e. from
rebooting of instrument is necessary to load the correct USB driver.
Alternatively, connect a USB cable to the
R&S NGE100B supports
Access:
1. Select "USB" menu item.
The R&S NGE100B displays the "USB" dialog.
Figure 6-18: USB dialog
2. Set the desired "USB Mode".
●
●
3. Press [Enter] key to confirm the settings.
The R&S NGE100B displays message to prompt the user to restart the instrument
to apply the changes.
4. Restart the R&S NGE100B to apply changes.
USB VCP
The following requirements for USB-VCP driver installation are necessary:
●
A PC with operating system Windows XP, VISTA, Windows 7 or Windows 8 (32Bit
or 64Bit).
●
Administrator rights are necessary for the installation of the driver.
User Manual 5601.1343.02 ─ 09
"USB TMC"
"VCP": USB virtual COM port
"TMC": USB Test & Measurement class
"TMC" to "VCP"
USB port and PC for a USB connection. The
and "USB VCP" connection.
Instrument functions
Interfaces and protocols
or vice versa), the
58