jcb JS200 Service Manual page 55

Hide thumbs Also See for JS200:
Table of Contents

Advertisement

Section 3
8 - 7
Draining Fuel Tank Impurities
Stop the engine and remove the key.
Loosen the drain tap A on the underside of the fuel tank.
Drain the water and deposits until clean diesel oil flows out.
Close the drain tap firmly.
! WARNING
!
Fuel oil is highly inflammable. Completely wipe off any
spilt fuel which could cause a fire.
8-3-4-3
Draining the Water Separator
The water separator should be drained at least every 50
hours, but more often if necessary.
Stop the engine and remove the key.
Open the drain plug B to release the accumulated water in
the bowl.
Under no circumstances should the float C be allowed to rise
above the red line D or water could get taken further into the
system with serious consequences.
Changing the Fuel Filter Element
1.
Stop the Engine
Stop the engine and remove the key.
2.
Disconnect the Battery
3.
Open the Engine Compartment
Locate the fuel filter (see Component Location
Diagrams at the end of this section).
4.
Remove the Element A
Using a chain wrench, unscrew the filter element from
the filter head. Avoid spilling the fuel retained in the
element.
5.
Fit the New Element
a. Smear the new filter element sealing ring with fuel oil
and hand tighten onto the filter head. Use a chain
wrench to tighten by a further
b. After installation, bleed the air.
c. Wipe up any spilled fuel.
9803/6400
Routine Maintenance
Engine (continued)
turn.
2
/
3
A
Section 3
8 - 7
D
C
B
Issue 1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Js210Js220Js240Js260

Table of Contents