jcb JS200 Service Manual page 415

Section E
92 - 6
Motor Assembly/Cylinder Assembly
*
Dismantling (cont'd)
20 Hold the end of cylinder 24 by hand and pull out the
cylinder assembly from housing 25.
Note: The oil seal 2 and the outer ring of taper roller bearing
3 remain in the housing.
The end face of the cylinder should be protected by clean
cloth to prevent it from being damaged.
Make alignment marks or write numbers on the piston bores
and the piston assemblies so that the piston assemblies can
be replaced in the same bores during reassembly.
22 Tap oil seal 2 with a screwdriver and hammer to remove
it from housing 25.
Note: The oil seal cannot be reused.
9803/6400
Hydraulics
Slew Motor
21 Remove the outer ring of taper roller bearing 3 from the
housing.
23 Remove the spring from cylinder 24.
Section E
92 - 6
Issue 2*