jcb JS200 Service Manual page 17

Section 2
3 - 1
Operating Safety
! WARNING !
The engine has rotating parts. Do not open the engine cover
while the engine is running. Do not use the machine with the
cover open.
INT-2-1-6
! ! WARNING
Entering/Leaving
Always face the machine when entering and leaving the cab.
Use the step(s) and handrails. Make sure the step(s),
handrails and your boot soles are clean and dry. Do not
jump from the machine. Do not use the machine controls as
handholds, use the handrails.
INT-2-1-7
! ! WARNING
You or others can be killed or seriously injured if you operate
the control levers from outside the cab. Operate the control
levers only when you are correctly seated inside the cab.
INT-2-1-3
! WARNING !
Accidents can be caused by working in poor visibility. Keep
windows clean and use your lights to improve visibility. Do
not operate the machine if you cannot see properly.
INT-2-1-11
! ! WARNING
Machine Limits
Operating the machine beyond its design limits can damage
the machine, it can also be dangerous. Do not operate the
machine outside its limits. Do not try to upgrade the machine
performance with unapproved modifications.
INT-2-1-4
! WARNING !
Exhaust Gases
Breathing the machine exhaust gases can harm and possibly
kill you. Do not operate the machine in closed spaces
without making sure there is good ventilation. If possible, fit
an exhaust extension. If you begin to feel drowsy, stop the
machine at once. Get out of the cab into fresh air.
INT-2-1-10
! WARNING !
Hazardous Atmospheres
This machine is designed for use in normal outdoor
atmospheric conditions. It shoul not be used in an enclosed
area without adequate ventilation. Do not use the machine in
a potentially explosive atmosphere, i.e. combustible vapours,
gas or dust, without first consulting your JCB Distributor.
INT-2-1-14
9803/6400
Engine
Controls
Visibility
Care & Safety
Water, mud, ice, grease and oil on ramps or trailers can
cause serious accidents. Make sure ramps and trailers are
clean before driving onto them. Use extreme caution when
driving onto ramps and trailers.
INT-2-2-6
Bad communications can cause accidents. Keep people
around you informed of what you will be doing. If you will be
working with other people, make sure any hand signals that
may be used are understood by everybody. Work sites can
be noisy, do not rely on spoken commands.
INT-2-2-3
Explosions and fire can be caused by sparks from the
exhaust or the electrical system. Do not use the machine in
closed areas where there is flammable material, vapour or
dust.
INT-2-2-10
Keep the machine controls clean and dry. Your hands and
feet could slide off slippery controls. If that happens, you will
lose control of the machine.
2-2-3-6
! WARNING !
Ramps and Trailers
! WARNING !
Communications
! DANGER !
Sparks
! WARNING !
Controls
Section 2
3- 1
Issue 1