Section J
13 - 2
Dismantling
Note: The following procedure is applicable to all bottom
rollers, but as there are visual differences, the illustrations
show only a typical unit.
1.
Clean the roller with a suitable solvent. Remove the plug
A and drain the oil.
2.
Remove locking wire B from each end of the shaft C.
Remove brackets D and E from shaft C.
3.
Remove seal F from brackets D and E, using a pry bar.
4.
Remove 'O'-rings G from shaft C.
Pull out shaft C from roller H or J.
9803/6400
Track and Running Gear
Bottom Roller (continued)
E
B
D
D, E
G
C
J
H
Section J
13 - 2
A
B
C
A
F
G
Issue 1