jcb JS200 Service Manual page 170

Section C
8 - 3
Self Test Function (continued)
The Self Check items can be displayed by pressing the
SELECT SWITCH after every singular display in the
following order.
When the SELECT switch is pressed the Engine RPM is
displayed
Pressing SELECT changes the display as shown.
With the S mode displayed it will show 330 mA, the H mode
will show 520mA, if the engine is at maximum speed
Pressing SELECT changes the display as shown.
With the throttle motor set at its minimum position it will
output approximately 620 pulses to a maximum of 1023 as
displayed in the clock display.
Pressing SELECT changes the display as shown.
Pressing SELECT changes the display as shown.
9803/6400
Electrics
Self Test
Message
CH : RPM
WORK MODE
CLOCK
Message
CH : PWM (mA)
WORK MODE
CLOCK
No. OF MOTOR TRANSMISSION PULSES
Message
CH : PLS
WORK MODE
CLOCK
HYDRAULIC OIL TEMPERATURE °C
Message
CH : OS
WORK MODE
CLOCK
Message
CH : WS
WORK MODE
CLOCK
ENGINE RPM
Self-check
MODE
Select
PUMP INPUT AMPERAGE
Self-check
MODE
Select
Self-check
MODE
Select
Self-check
MODE
Select
WATER TEMPERATURE °C
Self-check
MODE
Select
Section C
8 - 3
Issue 1