jcb JS200 Service Manual page 367

Section E
76 - 2
Reconditioning (continued)
Bushing press-fitting jig
a. Jig components
Part no
WDB 2166
WDB 2166-1
*
Note: The above Part No. indicates those for rod diameter 80 mm.
b. Special characteristics
If this special jig is used, anyone can press-fit the bushing into cylinder head quickly, easily and accurately without damaging
the cylinder head.
Wiper ring press-fitting jig
a. Jig components
Part no
WDB 2166-1
*
Note: The above Part No. indicates those for rod diameter 80 mm.
b. Special characteristics
By using this special jig, anyone can press-fit the wiper ring easily, quickly and accurately into the specified groove of the
cylinder head evenly without deforming or damaging it.
Cylinder head insertion guide jig
a. Jig components
Part no
WDB 2174
*
Note: The above Part No. indicates those for rod diameter 80 mm.
b. Special characteristics
By using this special jig, anyone can slide the cylinder head assembly onto the piston rod quickly, easily and accurately without
damaging any of the seals.
9803/6400
Part Name
Bushing press-fitting jig set
Chuck assembly
Retainer
Part Name
Jig for press-fitting wiper ring
(Retainer)
Part Name
Cylinder head insertion guide jig
Hydraulics
Hydraulic Rams
Qty
1
1
1 Also to be used for press-fitting wiper ring
Qty
1
Qty
1
Note
Also to be used for removing bushing
Note
Also to be used for removing bushing
Note
Section E
76 - 2
Issue 2*