jcb JS200 Service Manual page 419

Section E
92 - 10
Motor Assembly/Cylinder Assembly
*
Assembly (cont'd)
10 Mount the outer ring of the taper roller bearing into
housing 25.
12 Mount friction plate 9 and mating plate 10.
Note: Apply hydraulic oil to both faces before mounting the
plates.
9803/6400
Hydraulics
Slew Motor
11 Hold the end of cylinder 24 by hand and carefully insert
the cylinder assembly into housing 25. Use the seal
protector on the splines.
Note: The splines of the cylinder assembly protrude beyond
the housing, so use a guide of 30-50 mm (1.2-1.9 in) on the
lower part of the housing. Verify that spring 5 is inserted
correctly into the back face of retainer plate 7.
13 Mount 'O'-ring 11 in housing 25 and 'O'-ring 13 on piston
12.
Note: Grease the 'O'-rings before mounting.
Section E
92 - 10
Issue 2*