jcb JS200 Service Manual page 464

Section F
6 - 3
Removal (continued)
8. Support the motor so that the cables are in tension,
then remove the motor installation bolts.
Replacement
Before fitting, clean the gearbox and bleed air out as
1.
follows:
Turn the gearbox so that the hydraulic oil ports are
facing upwards.
Remove plugs from ports A and B. Fill the motor
through port A with the specified hydraulic oil. Fit
plugs to ports A and B.
2. Lift the gearbox and position it on the undercarriage.
Install the bolts and washers, using Loctite 262 on
the bolt threads. Tighten the bolts in a diagonal
sequence.
Torque Settings
267-312 Nm (196-229 lbf ft)
3. Remove plugs and install the hoses to the motor.
9803/6400
Transmission
Motor/Gearbox
Section F
6 - 3
Issue 1