Table of Contents
Advertisement
(LPF!L001 001 006 "Default")
(LPF!L001 001 007 "Default3D")
(LPF!L001 001 008 "Laser_Bhavana002")
(LPF!L001 001 009 "Laser_Bhavana_003")
(LPF!L001 001 010 "bhavana_008_laser")
(LPF!L111 "--END--")
LPM–Lamp Mode
Enables or disables LiteLOC
Parameters
•
Access Level: Operator
•
Power level (minimum): Power Up
Commands
Command
Description
LPM?
Returns the lamp mode for the active lamp file. (Read-only)
LPM <value>
Sets LiteLOC sensor level for the active lamp file.
LPM <0 | 1>
Enables or disables LiteLOC for the active lamp file.
Examples
Return the lamp mode for the active lamp file:
(LPM?)
Result:
(LPM! "0 080")
Where 0 indicates LiteLOC is disabled and the sensor level is set to 80.
Enable LiteLOC and set its sensor level to 60:
(LPM 1 60)
LVO–Lens Vertical Position Adjustment
Adjusts the lens offset to a specific vertical position with a specified direction.
In most cases the active lens is specified by the current channel. If a user selects a different lens file
in the ILS File Setup panel of the user interface, the selected lens file becomes active. This file may be
different from the one specified by the current channel.
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
and sets its sensor level.
™
CineLife+
serial commands
Values
—
value = Numeric value
0 = Disables LiteLOC
1 = Enables LiteLOC
19
Advertisement
Table of Contents
