Wheel Toe Alignment Inspection; Wheel Toe Adjustment - Polaris RZR 800 2013 Manual

Wheel Toe Alignment Inspection

1. Place machine on a smooth level surface and set
steering wheel in a straight ahead position. Secure
the steering wheel in this position.
2. Place a chalk mark on the center line of the front tires
approximately 10" (25.4 cm) from the floor or as
close to the hub/axle center line as possible.
NOTE: It is important the height of both marks
be equally positioned to get an accurate
measurement.
3. Measure the distance between the marks and record
the measurement. Call this measurement "A".
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
hub/axle center line.
5. Again measure the distance between the marks and
record. Call this measurement
measurement "B" from measurement "A". The
difference between measurements "A" and "B" is the
vehicle toe alignment. The recommended vehicle toe
tolerance is 1/8" to 1/4" (0.3 to 0.6 cm) toe out. This
means the measurement at the front of the tire (A) is
1/8" to 1/4" (0.3 to 0.6 cm) wider than the
measurement at the rear (B).
Wheel Toe-Out:
(A) - (B) = 1/8 to 1/4" (0.3 to 0.6 cm)

Wheel Toe Adjustment

If toe alignment is incorrect, measure the distance
between vehicle center and each wheel. This will tell you
which tie rod needs adjusting.
NOTE: Be sure steering wheel is straight ahead
before determining which tie rod needs adjustment.
"B". Subtract
During tie rod adjustment, it is very important that the
following precautions be taken when tightening tie rod
If the rod end is positioned incorrectly it will not pivot,
To adjust toe alignment:
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
MAINTENANCE
CAUTION
end jam nuts.
and may break.
• Hold tie rod end to keep it from rotating.
• Loosen jam nuts at both end of the tie rod.
• Shorten or lengthen the tie rod until alignment is as
required to achieve the proper toe setting as
specified in "Wheel Toe Alignment".
2
2.33