Support Bearing Replacement (Rzr 4) - Polaris RZR 800 2013 Manual

Table of Contents

Advertisement

Support Bearing Replacement (RZR 4)

1. Follow steps 1-8 of the "Removal / Installation
(RZR 4)" procedure.
2. Remove the bearing support (upper and lower half)
and the retaining ring. Loosen the (2) set screws
retaining the bearing to the shaft.
3. Remove the rubber isolator from the bearing and
slide the bearing off the end of the shaft.
NOTE: If bearing is seized on the shaft, remove
the rear portion of the shaft from the vehicle.
Refer to "Removal / Installation (RZR 4)".
4. Clean the mounting surface of the shaft and install
the new bearing.
5. Install a new retaining ring and slide the bearing tight
against the retaining ring.
6. Apply Loctite
7. Align the front and rear portions of the propshaft as
8. Install the rubber isolator over the bearing.
9. Install the upper and lower halves of the bearing
Support Bearing Fasteners:16-18 ft-lbs (22-24 Nm)
10. Install the front portion of the propshaft onto the front
11. Reinstall the center console, selector handle and
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
®
242™ to the set screw threads and
torque the (2) bearing set screws to specification.
Bearing Set Screws:30-35 in-lbs (3.4-4.0 Nm)
shown below and slide them together.
support along with the (2) fasteners. Torque the
support bearing fasteners to specification.
gearcase and install a NEW roll pin.
front seats.
FINAL DRIVE
7
7.17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rzr 800 2014

Table of Contents