Front Bearing Replacement - Polaris RZR 900 2017 Service Manual

Hide thumbs Also See for RZR 900 2017:

Table of Contents

FRONT BEARING REPLACEMENT

Bearing Removal

1. Remove the outer snap ring

2. From the back side of the bearing carrier, tap on the

outer bearing race with a drift punch in the reliefs as

3. Drive bearing out evenly by tapping on outer race

only. Once bearing is at bottom of casting, support

casting on outer edges so bearing can be removed.

4. Inspect the bearing carrier housing for scratches,

wear or damage. Replace front bearing carrier if

9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual

Bearing Installation

1. Thoroughly clean the front bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

2. Support the bottom of the bearing carrier housing.

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

3. Apply Loctite

retaining compound to the outer

circumference of the new bearing

carefully press the new bearing into the bearing

carrier housing.

Use care to not allow any of the Loctite

get in the bearing.

4. Wipe the housing clean of any excess compound and

install the snap ring

Table of Contents