Fuji Electric FE ZSS Instruction Manual page 5

ANGER
• When handling the standard gas such as calibration gas, read the instruc-
tion manual of the standard gas carefully, and use the gas correctly.
• When toxic fumes, corrosive gas or inert gas is used as calibration gas, be
sure that the position of the air ventilation or exhaust port is suitable. Oth-
erwise you may inhale exhaust gas. Furthermore, suffocation, brain dis-
order, circulatory deficit, or contraction of the breathing system may oc-
cur, resulting in death.
AUTION
• Do not touch the switch with a wet hand. Otherwise it may cause electric
shock.
• Do not operate the laser gas analyzer for a long time with its door left
open. Otherwise, dust, foreign matter, etc. may stick on internal walls,
thereby causing faults.
• Do not touch the unit terminal block during operation. Otherwise, it may
cause electric shock or injury.
• Before leaving unused for a long time or restarting after left at such a
status for an extended length of time, follow the directions of each in-
struction manual because they are different from normal starting or shut-
down. Otherwise, adequate performance will not be provided. Further-
more, an accident or fault may be caused.
• Do not allow water to go into the gas analyzer. Otherwise, electric shock
or fire in the instrument may be caused.
• Do not smoke nor use a flame near the gas analyzer. Otherwise, it may
result in a fire.
• Do not use the receiver unit or the transmitter unit as a footstool. Other-
wise, it may damage the analyzer, disable the correct measurement, and
besides, injury may result when the unit is removed.
• The product uses Class I laser.
• Do not remove the transmitter unit while the power is ON during opera-
tion. Also, do not direct the transmitter unit to people. Otherwise, laser
beam can enter eyes of people and damage its cornea.
• The laser beam is the invisible infrared light. Do not watch the laser beam
directly or scattering light.
• Do not watch the laser beam directly with the optical measuring device.
Otherwise, it may cause serious damage to your eyes.
• Be sure to purge the receiver unit and the transmitter unit. Do not use the
analyzer under the environment where high temperature gas is measured
and air purging is not performed. Otherwise, the analyzer may be dam-
aged.
Caution on operation and use
- iv -
INZ-TN1ZSS-E