Table of Contents
Advertisement
ANGER
AUTION
AUTION
INZ-TN1ZSS-E
Caution on maintenance and inspection
• When the analyzer (receiver unit and transmitter unit) is installed on in-
cineration facility, make sure the facility has stopped completely. Install-
ing on the operating facility may cause high temperature gas injection,
resulting in burn.
• If the analyzer is installed or removed from the location higher than op-
erator's height, set up a fence to keep someone from approaching under or
near the unit. If the analyzer inadvertently falls off and hits someone, se-
rious injuries may occur, resulting in death.
• When toxic fumes, corrosive gas or inert gas is used as calibration gas, be
sure that the position of the air ventilation or exhaust port is suitable. Oth-
erwise you may inhale exhaust gas. Furthermore, suffocation, brain dis-
order, circulatory deficit, or contraction of the breathing system may oc-
cur, resulting in death.
• Be careful not to drop the analyzer on your foot. Otherwise, it may cause
fracture of the bone.
• Do not touch the terminal block of each unit of the instrument carelessly
during operation. Otherwise, it may cause electric shock.
• Before working, take off a wrist watch, finger ring or the like metallic ac-
cessories. And never touch the instrument with a wet hand to avoid elec-
tric shocks.
• If the fuse is blown, eliminate the cause, and then replace it with the one
of the same capacity and type as before. Otherwise, it may cause electric
shock or accident.
• Do not wash or splash water on the switch or electrical parts inside the
device. Otherwise it may cause an electric shock, failure, or fire.
• Do not use replacement parts other than recommended ones. Otherwise,
adequate performance will not be provided. Furthermore, an accident or
fault may be caused.
• Dispose replacement parts such as maintenance parts as incombustibles in
accordance with the local waste disposal requirements.
• Do not remove the transmitter unit while the power is ON during opera-
tion. Also, do not direct the transmitter unit to people. Otherwise, laser
beam can enter eyes of people and damage its cornea.
• The laser beam is the invisible infrared light. Do not watch the laser beam
directly or scattering light.
• Do not watch the laser beam directly with the optical measuring device.
Otherwise, it may cause serious damage to your eyes.
Others
• If the cause of any fault cannot be determined despite reference to the in-
struction manual, be sure to contact your dealer or Fuji Electric's techni-
cian in charge of adjustment. If the instrument is disassembled carelessly,
you may get an electric shock or injury.
- v -
Advertisement
Table of Contents
