Standards; Table 2-6 Standards - maxon motor EPOS4 Module 24/1.5 Hardware Reference Manual

Specifications

Standards

2.5 Standards
The described device has been successfully tested for compliance with the below listed standards. In
practical terms, only the complete system (the fully operational equipment comprising all individual com-
ponents, such as motor, servo controller, power supply unit, EMC filter, cabling etc.) can undergo an
EMC test to ensure interference-free operation.
Important Notice
The device's compliance with the mentioned standards does not imply its compliance within the final,
ready to operate setup. In order to achieve compliance of your operational system, you must perform
EMC testing of the involved equipment as a whole.
Generic
Applied
Environment
Safety
Reliability
Table 2-6
2-16
Electromagnetic Compatibility
IEC/EN 61000-6-2 Immunity for industrial environments
Emission standard for residential, commercial and light-
IEC/EN 61000-6-3
industrial environments
IEC/EN 55022
Radio disturbance characteristics / radio interference
(CISPR22)
Radiated, radio-frequency, electromagnetic field immunity test
IEC/EN 61000-4-3
>10 V/m
IEC/EN 61000-4-4 Electrical fast transient/burst immunity test ±2 kV
Immunity to conducted disturbances, induced by radio-
IEC/EN 61000-4-6
frequency fields 10 Vrms
Environmental testing – Test Fc: Vibration (sinusoidal,
IEC/EN 60068-2-6
10...500 Hz, 20 m/s
Random transport (10...500 Hz up to 2.53 g
MIL-STD-810F
Unassembled printed circuit board
UL File Number • Module: E207844
• Compact CAN: E207844
Reliability prediction of electronic equipment
Environment: Ground, benign (GB)
Ambient temperature: 298 K (25 °C)
Component stress: In accordance with circuit diagram and
MIL-HDBK-217F
nominal power
Mean Time Between Failures (MTBF)
• Module: 611'610 hours
• Compact CAN: 326'977 hours
Standards
Document ID: rel6627
Edition: November 2016
© 2016 maxon motor. Subject to change without prior notice.
Others
)
2
EPOS4 Module/Compact 24/1.5 Hardware Reference
)
rms
maxon motor control
EPOS4 Positioning Controller