Agilent Technologies 1290 Infinity II 2D-LC User Manual page 197

8 Run the System
Configure the 2D-LC System
Configure 2D-LC Software
1 Configure the 2D-LC solution as 2D-LC Cluster, see
2 To check the correct selection of the individual components like sample loop,
3 Load the given reference method.
If you want to load and use a 1D method instead of a 2D method, make sure that
NOTE
the 2D-LC mode is deactivated.
System preparation and checkout run methods for recommended Infinity II
NOTE
system configurations are available on the Agilent 2D-LC Software data media.
Other configurations and modules require an adaption of the methods.
4 Check modes (Heart cutting or Comprehensive) and all other important
Except the pumps, all other units should have the pump set as the stop time.
NOTE
2D-LC User Guide
Cluster" on page 96.
transfer capillary and ASM capillary (if applicable), use the context menu
function Modify.
Correct the selection if necessary.
parameters in the method before starting the run.
"Configure the 2D-LC
197