Agilent Technologies 1290 Infinity II 2D-LC User Manual page 170

6 Method Parameters
Set up a Peak-Based Experiment Graphically
To generate a peak based event in the preview, you can also use the add icon or
NOTE
do a right click somewhere into the preview, and press add cut.
In the sampling table you can add the events start and end peak-based, see
Peak Trigger"
For adjusting the peak-based area it can be either be done by grabbing start and
end bracket and moving along in the preview or by adjusting the times in the
sampling table.
2D-LC User Guide
Figure 85 Two selected peaks in peak based mode and corresponding peak-based sampling
table
on page 148 .
"Use
170