Agilent Technologies 1290 Infinity II 2D-LC User Manual page 109

5 2D-LC Data Acquisition in MassHunter Workstation 11
2D-LC User Interface
Figure 55
Flow
Pressure
Pressure Limit
Composition A:B
Prepare Pump
2D-LC Valve position
Deck A Valve position
Deck B Valve position
Diverter Valve Position
Tuning
For further information, see the pump user manual.
NOTE
2D-LC User Guide
Full view of the 2D-LC UI
The current solvent flow rate (in mL/min).
The current pump pressure (in bar, psi or MPa)
The current maximum pressure limit.
The current solvent composition. When a solvent selection valve is fitted,
the channels are shown in the graphic.
The info represents the current pump status.
The info represents the current 2D-LC Valve status. In the current setup an
ASM Valve(Position 1-5) is installed see
(G4243A)" on page 70
The info represents the current MHC Valve status Deck A (Position 1-6)
The info represents the current MHC Valve status Deck B (Position 1-6)
The info represents the current valve position (Position 1 → Into MSD,
Position 2 → Into waste).
The signal represents the current effort the pump drives have to take to
maintain the current system status.
"Connecting the 2D-LC Valve, ASM
109