Walkthrough Stage Three, Port 10 Egress Setting - Enterasys SmartSwitch 6000 User Manual

Figure 13-8 Walkthrough Stage Three, Port 10 Egress Setting
Configuring the Port Parameters
Now that the TEST VLAN and the trunk connection are set up, we can proceed to set the port
parameters for ports 3 and 10, as follows:
1. On the 802.1Q Configuration Menu screen, use the arrow keys to highlight the
VLAN PORT CONFIGURATION menu item and press ENTER. The VLAN Port
Configuration screen displays.
2. Use the arrow keys to highlight the PVID field for Port 3.
3. Type in 2, which is the VLAN ID of the Test VLAN. This will associate Port 3 with the
VLAN ID, thus making the port PVID of 2.
NOTE: Since Port 3 will connect to a single workstation, and is not to be used for
switch-to-switch communications, the acceptable frame types allowed through this port
will be all frame types (tagged and untagged). Since Port 3 will not receive VLAN frames
from the work station, it is not necessary to filter frames.
VLAN Operation and Network Applications
Quick VLAN Walkthrough
13-19