Display Fields; Input Fields; Selection Fields; Command Fields - Enterasys SmartSwitch 6000 User Manual

Local Management Screen Elements

Display Fields

Display fields cannot be edited. These fields may display information that never changes, or
information that may change as a result of Local Management operations, user selections, or
network monitoring information. In the screens shown in this guide, the characters in the display
fields are in plain type (not bold). In the field description, the field is identified as being
"read-only".

Input Fields

Input Fields require the entry of keyboard characters. IP addresses, subnet mask, default gateway
and module time are examples of input fields. In the screens shown in this guide, the characters in
the input fields are in bold type. In the field description, the field is identified as being
"modifiable".

Selection Fields

Selection fields provide a series of possible values. Only applicable values appear in a selection
field. In the screens shown in this guide, the selections display within brackets and are in bold
type. In the field description, the field is identified as being either "selectable" when there are more
than two possible values, or "toggle" when there are only two possible values.

Command Fields

Command fields are located at the bottom of Local Management screens. Command fields are
used to exit Local Management screens, save Local Management entries, or navigate to another
display of the same screen. In the screens shown in this guide, the characters in this field are all
upper case and in bold type. In the field description, the field is identified as being a "command"
field.
Introduction 1-7