Setting The Reset Peak Switch Utilization; System Resources Information Screen Field Descriptions - Enterasys SmartSwitch 6000 User Manual

Field Descriptions
Refer to Table 5-8 for a functional description of each screen field.
Table 5-8 System Resources Information Screen Field Descriptions
Use this field...
CPU Type
(Read-Only)
Flash Memory
Installed
(Read-Only)
DRAM Installed
(Read-Only)
NVRAM Installed
(Read-Only)
Current Switch
Utilization
(Read-Only)
Peak Switch
Utilization
(Read-Only)
Reset Peak Switch
Utilization
(Toggle)
5.7.1

Setting the Reset Peak Switch Utilization

To set the Reset Peak Switch Utilization field to YES or NO, proceed as follows:
1. Use the arrow keys to highlight the Reset Peak Switch Utilization field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
4. Press ENTER. The message "SAVED OK" displays and the Reset Peak Utilization counter
resets to zero.
To...
See which microprocessor is used in the switch module.
See the amount of FLASH memory that is installed in the switch
module and how much is currently available.
See the amount of DRAM installed in the switch module and how
much of it is currently available.
See the amount of NVRAM that is installed in the switch module and
how much of it is currently available.
See what percentage of the module switching capacity is currently
being used.
See the peak percentage of module switching capacity used, since the
last reset.
Reset the Peak Switch Utilization field. The switch may be set to either
YES or NO as described in
Utilization field to the current system utilization.
System Resources Information Screen
Section 5.7.1. YES resets the Peak Switch
Module Configuration Menu Screens 5-31