Enterasys SmartSwitch 6000 User Manual page 363

rate_limit_mode
Description:
Displays the status of rate limiting or configures the exit-rate limit range to
either the default high_range (100 Kbps to 1 Gbps) or the low range (50 Kbps
to 400 Mbps). This mode is stored in non-volatile memory and is retained by
normal resetting. Changing from one mode to the other mode may result in
current settings being removed if their range is no longer valid. Changing rate
limit mode will require a reset.
Syntax:
rate_limit_mode [ status ] [ high_range (default) ] [ low_range ]
Options:
status — Displays rate limiting status.
high_range — Sets the default rate limit high range.
low_range — Sets the default rate limit low range.
Examples:
-> rate_limit_mode status
Rate Limit Mode is: High Range (100Kbps - 1 Gbps).
-> rate_limit_mode low_range
This will reset board : Are you *SURE* ?
-> rate_limit_mode high_range
This will reset board : Are you *SURE* ?
Built-in Commands
Network Tools Screens 12-27