Enterasys SmartSwitch 6000 User Manual page 364

Built-in Commands
reset
Description:
Syntax:
Options:
Example:
sat_size
Description:
Syntax:
Options:
Example:
12-28 Network Tools Screens
Initiates a hardware reset of the device. This command initializes the CPU
processor, runs the onboard diagnostics, and restarts the software image,
which restores the user configuration settings from NVRAM. The user will be
queried to confirm the reset command to ensure against unwanted resets.
NOTE: The Network Tools connection to the device will be
terminated upon execution of this command.
reset
None
-> reset
RESET: Are you *SURE
-> Y
Displays the current setting or sets the size of the Source Address Table
(Forwarding Database) on the device to either 8000 or 16000 entries. The
default is 8000 entries. When set to 16000, 400 Layer 2/3/4 VLAN
Classification and Priority Assignment entries will be supported. The default
is 1000 Layer 2/3/4 VLAN Classification and Priority Assignment entries.
Changing of sat_size will lead to a reset of the board.
sat_size [ 8 | 16 | status ]
8 — Sets the size of the Source Address Table to 8000 entries.
16 — Sets the size of the Source Address Table to 16000 entries.
status — Displays the current size setting for the Source Address Table.
-> sat_size status
sat size status is 8.