Enterasys SmartSwitch 6000 User Manual page 348

Built-in Commands
gigabit_port_mode
Description:
Syntax:
Options:
Examples:
igmpv3_drop
Description:
Syntax:
Options:
Examples:
12-12 Network Tools Screens
Configures or displays the status of Gigabit Ethernet ports. Changing the
mode will cause a reset and loss of all data in NVRAM with the exception of
the IP Address and Subnet IP Address.
NOTE: This field is displayed only when the switch module
supports an installed Gigabit Ethernet VHSIM.
gigabit_port_mode [active | redundant | status]
active – Enables both gigabit ports.
redundant – Causes Port 1 to be active and Port 2 to be set up as a
redundant port.
status – Displays the current status of the gigabit port.
-> gigabit_port_mode status
gigabit_port_mode is redundant
-> gigabit_port_mode active
This will reset board and cause loss of persistent objects
except IP Address and Subnet: Are you *SURE* ?
Enables, disables or displays the status of igmpv3_ drop on Ethernet front
panel ports.
igmpv3_drop [enable | disable | status]
enable — Enables igmpv3 drop on Ethernet front panel ports. This is the
device default state.
disable — Disables igmpv3 drop on Ethernet front panel ports.
status — Displays the current state of igmpv3_drop on the device.
-> igmpv3_drop enable
-> igmpv3_drop disable
-> igmpv3_drop status
igmpv3 drop is Disabled.