Enterasys SmartSwitch 6000 User Manual page 75

Table 3-8 Radius Configuration Screen Field Descriptions (Continued)
Use this field...
Last Resort
Action/Local
(Selectable)
Last Resort
Action/Remote
(Selectable)
Radius Client
(Toggle)
IP Address
(Modifiable)
Secret
(Modifiable)
Auth Port
(Modifiable)
To...
Accept, Challenge, and Reject, which do the following:
ACCEPT: Allows local access (via COM port) at the super-user
level with no further attempt at authentication.
CHALLENGE: Reverts to local module (legacy) passwords.
REJECT: Does not allow local access.
For more details, refer to
To set local and remote servers, refer to
Accept, Challenge, and Reject, which do the following:
ACCEPT: Allows local access (via COM port) at the super-user
level with no further attempt at authentication.
CHALLENGE: Reverts to local module (legacy) passwords.
REJECT: Does not allow remote access.
For more details, refer to
To set local and remote servers, refer to
Enable or disable client status.
Enter the IP address (in decimal-dot format) of the primary and
secondary servers being configured for the Radius function.
Enter a secret string of characters or the primary and secondary server
(16 characters are recommended as per RFC 2865. The maximum is 32
characters).
Enter the number of the Authorization UDP Port for the Primary and
Secondary server.
Radius Configuration Screen
Section 3.9.1.
Section
Section 3.9.1.
Section
Accessing Local Management
3.9.2.
3.9.2.
3-33