Port Configuration
Setting Port Auto-Negotiation
4.2.3
Setting Port Auto-Negotiation
Purpose
To determine whether auto-negotiation is enabled or disabled for the specific port and to set the
state, and to display or set a port's advertised mode of operation. During auto-negotiation, the port
"tells" the device at the other end of the segment what its capabilities are.
Commands
The commands needed to configure auto-negotiation are listed below and described in the
associated section as shown.
•
show port negotiation
•
set port negotiation
4-14
Matrix E1 Series (1G694-13) Configuration Guide
(Section
4.2.3.1)
(Section
4.2.3.2)