Completing Installation; Scsi Led Connector - Adaptec AHA-3940 User Manual

2
Connect the LED cable to the SCSI activity LED connector on
the host adapter, as shown in Figure 2-14.
LED Cable
Figure 2-14. SCSI LED Connector
If the computer has a two-position LED cable, connect it to
pins 1 and 2 of the LED connector.

Completing Installation

Before you reassemble your computer, be sure that
The devices on each SCSI channel are properly terminated
Each SCSI device on each SCSI channel is set to a unique SCSI
ID
The host adapter is firmly seated and secured in a 5-volt bus
master PCI bus slot
Internal SCSI devices are firmly connected to the host adapter
and pin-1 orientation is correct
External SCSI devices are firmly connected to the host adapter
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-3940/3940W User's Guide
A
A A
Stock Number: 510600-00, Rev. A
A A
A A Print Spec Number: 492707-00
A A
Current Date: 8/24/94
A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Installing Your Host Adapter and SCSI Devices
LED Connector J3
Page: 2-17
ECN Date: 08/30/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
Pin 1
2-17
A
A A
A A
A A
A
A A
A A
AAAA A A A A