First-Time Operation - Advanced Energy HFV 8000 User Manual

®
Advanced Energy
This generator must be used in a pollution degree 2 or better
environment.
This device must be used in an overvoltage category II installation only.
Make input power connections and wire terminations in accordance with
local safety requirements.
Check for proper power requirements at the source and then connect input power,
ensuring the following:
• The 8 AWG yellow/green wire must be connected to ground.

FIRST-TIME OPERATION

Before proceeding, be sure the setup of the HFV generator is complete (see
the HFV generator" on page
The HFV generator can operate without being connected to either a
chamber or a dummy load. You are exposed to high voltage output from
the generator if you do not hook the output to either a chamber or a
dummy load.
Note: If using a dummy load (50 Ω), connect the HFV generator to the load with an
RG-393 cable and an appropriate load. If you connect the generator to your
chamber, be sure to satisfy all chamber conditions for operation.
5-8
5-2).
Installation, Setup, and Operation
"Installing
5705211-C